SACKit WOOfit JAM Bedienungsanleitung Seite 10

Connect to WOOFit JAM
Bluetooth connection
1. Press "Play/Pause Button" for
3 seconds. When the indicator
light shows fast blue and red flash
alternatively, the WOOFit JAM enters
pairing mode. (Notes: Pairing mode is
cancelled after 3 minutes, along with
a "Beep" sound. If you want to enter
into pairing mode again, start over
from step 1). As soon as your device
is paired with the WOOFit JAM the
indicator light turns flashing blue.
2. Perform the pairing procedure
on the Bluetooth device to detect
the system. A list of detected
devices appears on the display of
UK
the Bluetooth stereo audio source
device. This system is displayed as
9
Downloaded from www.Manualslib.com manuals search engine
"WOOFit JAM". If "WOOFit JAM"
is not displayed, repeat from step 1.
(Note: When pairing, be sure to keep
both Bluetooth devices within 1 meter
range of each other.)
3. Select "WOOFit JAM" shown in the
display of the Bluetooth device.
4. Option: If Passcode * input is required
on the display of the Bluetooth device,
input "0000". (Note: Passcode may
be called "Passkey", "PIN code", "PIN
number" or "Password")
5. Start the Bluetooth connection from
the Bluetooth device. The system
remembers the device as the last
connected device. Some Bluetooth
devices may connect with the
system automatically when pairing is
complete.