Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SHADE GUIDE TABLE
Welding Process
SMAW
MIG(heavy)
MIG(light)
TIG,GTAW
MAG/CO2
SAW
PAC
PAW
NOTE:
SMAW – Shielded Metal Arc Welding
MIG (Heavy) – MIG on Heavy Metals
PAW – Plasma Arc Welding
SAW – Shielded Semi-Automatic Arc Welding
• REPLACE THE FRONT COVER LENS. Replace the front cover lens if it is damaged
(cracked,scratched,dirty or pitted) Place your finger or thumb into the recess at the bottom
edge of the wirdow and flex the window upwards until it releases from one edge (See fig.6).
• REPLACE THE INNER COVER LENS. If it is damaged (cracked, scratched, dirty or pitted).
• CHANGING THE SHADE CARTRIDGE (See figs.6a & 6b).
• INSTALLING NEW CARTRIDGE. Take the new shade cartridge and pass the potentiom-
eter cable under the wire loop before dropping the cartridge into its retaining frame inside
the helmet. Press down the wire loop clip and ensure that the front edge of the loop is
properly retained under the retaining lugs as shown in fig.6b.
• Fasten the potentiometer to the inside of the helmet with the shaft protruding through the
hole. Push the shade control knob onto the shaft.
• CLEANING. Clean helmet by wiping with a soft cloth. Clean the auto darkening filter
surfaces regularly. Do not use strong cleaning solutions.Clean sensors and solar cells with
methylated spirit and a clean cloth and wipe dry with a lint-free cloth.
fig.6
2.5
0.5
10
20
1
15
5
9
8
9
10
fig.6a
ARC CURRENT（Amperes)
80
125
40
30
60
100
150
10
11
9
10
11
10
11
11
10
12
10
11
11
11
12
TIG, GTAW – Gas Tungsten Arc Welding
MIG (Light) – MIG on Light Alloys
PAC – Plasma Arc Cutting
MAG/CO2 - Metal Active Gas
- 5 -
175
225
275
200
250
300
12
12
12
13
13
12
13
10
11
12
12
13
14
(NO.1)
350
450
400
500
13
14
14
13
14
15
14
14
15
13
14
15
13
15
fig.6b
Werbung
Inhaltsverzeichnis
