Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 1
Open the DCP Wave device with
a screwdriver
Step 6
Check the signal strength by
using the built-in signal strength
scanner. To use the signal
strength scanner function:
1) Turn SW1 dipswitch to ON
2) LEDs will show the network
signal level
3) Once finished, turn SW1 to off
4) Default settings - 1: OFF, 2:
OFF, 3: OFF, 4: ON
Step 7
Connect the power supply
230VAC to connector (8) using
the 2 pin connector supplied in
the unit. (Power supply wires:
non-polarised connection)
You can check the status of the power supply, battery, connection, coverage or Phone
line at any time by referring to the LED indicators.
Run LED flashes in green
BAT LED is always on
SIM LED is green or amber
Coverage LED is green or amber
SLIC LED is green
Note: If a non-Avire SIM is used:
•
APN settings must be set prior to configuring it on the Avire Hub; please refer to
"Setting Parameters on non-Avire SIM cards".
•
If the SIM LED is flashing red, please see "SIM Card unlocking".
•
Make sure to check with the network provider to ensure the SIM is compatible with
2G/4G, depending on the DCP WAVE device purchased.
Step 2
Connect the antenna on the
DCP to connector (1) and ensure
it is cmpletely tightened. Only
use antennas authorised by
Avire, other the device might
not work.
Step 5
Wait for the LED lights to turn
on. Check the SIM LED to make
sure it is green or amber. If it is
flashing red check its
been inserted correctly
and then unlock the
SIM using instructions
in 'how to unlock the
SIM Card' section of
the install guide.
Step 8
Clamp the power cable using
the grey clamp provided inside
the box
Step 9
Place the lid back on the top of
the DCP WAVE and fasten the
lid with the screw.
Step 3
Insert SIM into connector (2)
pushing the SIM until it clicks
into place. Refer to SIM Card
unlocking section
for details on how
to avtivatre the SIM
Card.
Step 4
Connect the battery to
connector (3). This must be
connected to provide battery
backup in an event of a power
faliure.
Step 10
Turn on the power to the DCP
Wave. The RUN LED on the
Wave should change colour
from flashing amber to flashing
green when the mains power
connection is made. If you see
any other colour please consult
the LED indication list below.
Power supply is OK
Battery is OK
Device is connected to the network
Good coverage
Device is in standby
3
Werbung
