Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11. Setting the Drag Brake (Engine Brake)
The drag brake simulates the friction of the brushes of brush motors.
Flashing
frequency
Drag brake (%)
•
Press the SET button down until the blue LED light up 4 times. Release the SET
button again.
•
The red LED start flashing. This shows that you are in the mode for setting the
parking brake.
•
Press the SET button repeatedly until you reach the required setting.
The red LED flash at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
•
When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
•
Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
1
2
3
OFF
5
10
CARSON DRAGSTER Brushless-Regler
4
5
6
7
15
20
25
30
8
9
10
35
40
45
Blue LED
Red LED
GB
41
Werbung
Kapitel
Inhaltsverzeichnis
