Troubleshooting - Solight Te50 Bedienungsanleitung

Verfügbare Sprachen

Presentation of measurement results -

measurement of human body temperature

When the temperature is lower than 37.5 ℃, the

green backlight of the display will appear (Fig. 1). At

a temperature between 37.5 ℃ - 39 ℃, the yellow

backlight of the display will light up (Fig. 3). At

temperatures above 39 ℃, the red backlight of the

display appears (Fig. 2).

Battery replacement (not included)

The device can be used up to approx. 10,000 times per battery (depending on the quality). If the battery symbol flashes on

the display, it means that the battery is low and needs to be replaced. Do not use rechargeable batteries or use this product

with one battery for more than half a year

Routine maintenance

1. Pay attention to external cleaning, and wipe the dirt with alcohol or disinfectant;

2. Internal dirt: do not wipe with hands, wipe the lens surface with cotton swab stained with more than 95% anhydrous

alcohol;

Storage: please keep in a dry and dark place out of direct sunlight

Troubleshooting

1. The temperature displayed on the screen is greater than 95 ℃, and the temperature is Fahrenheit, which is converted into

Celsius

2. The temperature mode of the screen display itself is lower than 32 degrees, and the temperature mode should be converted

into a body in the "surface temperature" mode

3. „Hi" information is displayed on the screen. In the temperature mode, when the measured temperature is higher than 42.9

degrees, the product will display hi. First, confirm the working mode of the product. In the temperature mode, the measured

human body will still display hi. First, check whether the measured part of the human body has contacted the external heat

source. If not, contact our technical personnel

4. The screen displays „Lo" information. In body temperature mode, when the measured temperature is lower than 32 ℃, the

instrument will display lo. Confirm that the instrument is in surface temperature or body temperature mode, and the measured

human body still displays lo. First, find out the reason according to the following table. If it is confirmed that it is not the reason

in the table, contact the technical personnel.

The main reasons for the display of „Lo" are as follows:

There is hair or sweat when reading the temperature;

There is cold air blowing on the forehead;

Make sure there is no obstacle or sweat on the forehead;

The forehead has just been cold applied;

The measuring distance is too far

The product is issued with a CE declaration of conformity in accordance with applicable regulations. On request from the

manufacturer: info@solight.cz, or for download at www.solight.cz. Manufacturer: Solight Holding, s.r.o., Na Brně 1972,

Hradec Králové 500 06, Czech Republic