Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly Instructions: Eiermann 1 Table Frame Regular / Offset
4 pc. Threaded stoppers, dia. 20mm for lower table frame
4 pc. Threaded stoppers, dia. 16mm for upper table frame ext
4 pc. Rubber stoppers for upper table frame extensions
(must be ordered separately)
4 pc. Allen bolts M6x30mm
Please follow these instructions to assemble your Eiermann Table Frame:
1.
Push the four threaded stoppers
one of the leg frames and the table cross-brace to hand.
2.
Attention:
when unscrewing the Allen bolts from the cross-brace, be aware of the unusual angle in the next step. Do
not use an Allen key to screw the bolt into the first thread hole, otherwise you risk damaging the threads. Please be
aware of the angle at which the bolt is screwed in!
bolt.
3.
Using your left hand, hold the cross-brace and the leg frame together, so that the cross-brace comfortably engages on
the top and bottom horizontal of the leg frame and so that the other end of the cross-brace is just touching the floor.
Attention! Place a piece of cardboard from the packaging under the cross-brace where it touches the floor, to avoid any
scratches.
4.
Now, by hand, screw in the Allen bolt
5.
Take the other leg frame and repeat step 5. Use an Allen key to gently tighten all four bolts in their threads.
6.
Place the table frame in the desired position.
7.
Take the extension tubes and push the threaded stoppers
purchased separately), using a little lubricant (e.g. washing up liquid ) to ease it into the tube.
8.
Check the fit of the extension tubes in leg frames: If the extension has a bit too much "play" and rattles in the side
frame, you can reduce the thickness by wrapping sellotape around them.
9.
Now, determine the height of the table top. Place the adjustment keys
tubes. In the top hole, the table top will have a height of 725mm. The table top can be adjusted in 35mm increments.
Now place the extension tubes, with the adjustment keys in place, into the leg frames. Attention: only use up to the
third hole on the extension tubes, otherwise the table will become unstable.
10. Place the table top on the frame and check whether the leg frames are square. The frame can be squared manually by
carefully pulling the leg frames apart or pushing them together.
11. Finally, tighten up all four Allen bolts
Notes:
12. If the floor is too uneven, please use the levelling set (available separately).
13. To fix the table top or place it at an angle, please use the fixing kit (also available separately).
14. Further accessories can be found on our priceless or on our website.
into the longer ends of the left and right leg frames. Have two Allen key bolts
Tip: if you have a little grease to hand, put some on the end of the
three or four turns into the thread.
in. Alternatively, use the rubber stopper set
.
4 pc. Adjustment keys
in the pre-drilled holes in the extension
,
(must be
Werbung
