Connector; Connecting Charging Unit - Seat MÓ Betriebsanleitung

The wheels and base of the pack slide out
and fold up automatically when it is removed
or inserted into the eScooter, respectively.
Nevertheless, it is your responsibility to do this
slowly and make sure the wheels and base
deploy correctly, and that when putting it
back in, it is properly anchored (check before
driving).
¬ WARNING
Never remove or insert the battery pack
when the eScooter is charging or with the
ignition switched on.
O CAUTION
Do not unfold the handle before pulling
the pack out. Unfold the handle once the
battery is away from the eScooter.
Note
When the battery does not make good
contact with the eScooter, the following
message is displayed on the instrument
cluster:
B A T T O U T
When connected correctly, the usual
information is displayed.
Battery pack
32

Connector

Connector cap
Fig. 32
Whenever the battery is not in the eScooter,
the eScooter's (Multicontact) connector must
be covered with the rubber cap designed for
this purpose. Its purpose is to protect it while
the battery is disconnected.
¬ WARNING
Do not put the protective cap on while the
eScooter is plugged in and never allow
the connector to get wet (even with the
cap on).

Connecting charging unit

Rear of the Battery Pack: charging
Fig. 33
socket
2
Right hand side of the eScooter:
Fig. 34
charging socket
1