3.2 Interfaces and sensors
Connection to the supply lines
Please connect the device to all necessary supply lines before you assemble it into the
built-in box. Attach the wiring in accordance with the following illustration. Please ensure
that the power supply is connected correctly. A suitable connector is part of the delivery.
For systems with PoE (Power over Ethernet) the network hub must be PoE ready, to pow-
er the device by the Ethernet cable.
Temperature sensor - conditions of use
When using the temperatur sensor an offset of +1°C must be set in the application. The
values of the temperature sensor only can be used, if the system's „display off" time is
configured to less then 5min (System is set to 1 minute by default).
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Seite 25 von 66