Werkzeyt B29865 Bedienungsanleitung Seite 5

Operation
Switching on/off:
You can switch on the lamp by pushing the button at the front.
Choosing the lighting mode:
After switching on the lamp, you can switch between the following
modes by lightly pushing the button:
1.) 100 % white
2.) 40 % white
3.) 40% red
4.) 40% flashing red
5.) switch off
or
Before or after switching on the lamp, you can activate the sensor
mode by pushing the button longer. With the sensor mode, you
activate or deactivate the lamp by swinging your hand in front of
the lamp.
Recharging the battery:
To charge the battery, open the USB protection at the bottom of
the lamp and connect the micro USB cable of the charger with the
headlamp and then plug the power supply into the power outlet. The
device is fully charged after about 2 hours.
Use as table lamp or pin lamp:
In order to use the headlamp as a table lamp or pin lamp, remove
the head strap on both sides of the lamp using the pre-defined
recess.
For use as a table lamp, place the rack on a flat surface and align it
in the requested direction using the 360°hinge.