Connecting To Network - Korenix JetNet 6059G Serie Schnellinstallationsanleitung

Downloaded from www.Manualslib.com
Wiring the Digital Input (DI)
The Digital Input (D.I.) contacts are in the bottom side of the device as shown in Figure-4.
It accepts one external DC type signal input and can be configured to send alert message
through Ethernet when the signal is changed.
Note: the DI accepts DC type signal and supports isolated input circuit with Digital High
Level input DC 11V~30V and Digital Low Level input DC 0V~10V. Don't apply higher
voltage than the specification; it may cause internal circuit damage or a wrong action of DI.

Connecting to Network

1. Connecting the Ethernet Port: Connect the Ethernet port of JetNet 6059G with the
other Ethernet device by Cat-5/Cat-6 UTP or STP cable, and then the LNK/ACT LED will
turn on and start flashing to indicate the communication is occurred between 2 devices.
2. Connecting the SFP Port: Plug in SFP fiber transceiver. We recommend using Korenix
certificated SFP mini GBIC transceiver. Cross-connect the transmit channel at each end to
the receive channel at the opposite end as illustrated in the Figure-5.
ATTENTION
This is a Class 1 Laser/LED product.
Don't stare at the Laser/LED Beam.
manuals search engine
Figure-4
TX TX
RX RX
A B
Figure-5