Herunterladen Diese Seite drucken

Werbung

Wots Wot FOAM-E Instructions / Wots Wot FOAM-E Anleitung
Stage 18 / Schritt 18
Remove the two screws securing the spinner and use
a 10mm driver to clamp the propeller to the motor shaft.
Once secure reinstall the spinner but be careful not to over
tighten the screws.
Entfernen Sie die beide Sicherungsschrauben des
Spinners. Mit einem 10mm Schlüssel ziehen Sie jetzt den
Propeller an der Motorwelle fest. Jetzt kann der Spinner
wieder mit den Schrauben befestigt werden. Achten Sie
dabei darauf, dass Sie die Schrauben nicht überdrehen..
Installing the Battery / Akku installieren
Slide the moulded plastic battery catch to release the hatch.
The recommended battery is a 3S 2100~2500mAh Li-Po with a 30C
discharge rate. This should fit neatly into the moulded battery slot
provided and will be secured by a foam block on the bottom of the
hatch. If your battery is oversized then you may need to trim this
block to fit. Run the wires & connectors to the side of the battery.
Then simply slot the hatch in place and lock the catch to secure.
Entriegeln Sie den Plastikriegel der Akkufachabdeckung,
damit Sie den Deckel entfernen können. Wir empfehlen Ihnen
einen 3S 2100-2500mAh Li-Po Akku mit 30C Entladungsrate.
Dieser sollte genau in das vorgeformte Akkufach passen, und
wird durch einen angegossenen Schaumblock an der Unterseite
des Deckels gesichert. Ist der Akku zu groß müssen Sie den Block
auf die passende Größe zuschneiden. Lassen Sie die Kabel und
Verbindungsstecker an der Seite des Akkus entlang laufen. Dann
den Deckel wieder in die Öffnung setzen, und den Verschluss
wieder verriegeln.

Control Throws

For initial flights, we recommend the following
control throws - each measured at the widest
point of the surface:
Elevator: 13mm up
13mm down
Rudder:
50mm left
50mm right
8
Ailerons: 10mm up
10mm down
Ruderausschläge
Für den Erstflug empfehlen wir folgende
Ruderausschläge. - Jeder wird am weitesten
Punkt der Ruder gemessen:
Höhe: 13mm hoch
13mm runter
Ruder: 50mm links
50mm rechts
Querruder: 10mm hoch
10mm runter

Werbung

loading