Samsung 4 Serie Benutzerhandbuch Seite 20

Item
Sound Advanced
Search for channels
Automatic channel update
Channel update message
Digital: Reception test
Broadcasting
Analogue: Manual
installation
Common interface
Use Mode
Shop setup
System
Factory settings
Setup
CAM Operator profile
CAM Profile Name
20
English
Description
• Digital out levelling: Level out the volume from device
which is connected to DIGITAL AUDIO OUT(OPTICAL).
• Digital out delay: Adjust the delay time of the sound
output from DIGITAL AUDIO OUT(OPTICAL) terminal.
• Digital out offset: Set an audio offset If you cannot
set a sound delay on the Home Theatre System. (Only
available when Digital out delay set to On)
Start updating the current channels or redo a complete
installation channels.
Automatically search for the receivable channels.
When new channels are found, a message is shown at TV
start up.
Manually install digital channels. If the reception is poor,
check and reposition your antenna.
Select Search to check the signal quality.
Manually install analogue channels.
• System: Select the country and the TV system.
• Search Channel: Enter a frequency to find a channel.
• Fine tune: Fine tune a channel.
• Store current channel / Store as new channel: Store a
found channel on the current channel number or as a
new channel number.
If prepaid premium content is available from a CAM, you
can set the provider settings with this option.
(Only available when you insert CAM card)
Select the Use Mode suitable for your place.
• Home Use: It is the default setting.
• Store Demo: It is for retail environments only. If
you select Store Demo, Picture Mode will change to
Dynamic every 10 minutes.
• Feature logos: Select On / Off to show the e-sticker.
(Only available when the Store Demo is selected in Use
Mode)
It will reset all the personal settings.
The channel installation remains unchanged.
Reinstall and redo the TV installation completely.
This enables the user to allow the CI+CAM operator profile
which is for easy channel installation and updating.
Show the current using CAM profile name.
(Only available when you insert CAM card)