digital 3220 Serie Installationshandbuch Seite 12

Expansion boards continued
SCSI Configuration Utility
If a SCSI option has been added to your server, you may
run the SCSI Configuration Utility to configure the newly
added card(s) or disk drive(s).
Press Ctrl + C when prompted during the boot process to
run the SCSI Configuration Utility.
Refer to your System Reference manual for additional
information on this utility.
NOTE
If you installed SCSI cards, make sure that the MS-DOS
partition resides on the boot device. If not, shut down the
server, change the order of the cards and reconfigure your
server. Refer to the device scan sequence later on this
page.
Mylex Configuration Utility
If the server detects the presence of a Mylex
ler, the RAID utility is invoked. This utility allows you to
configure any newly installed RAID devices.
12
Downloaded from www.Manualslib.com
™ RAID control-
manuals search engine
Device Scan Sequence
Devices are identified and initialized in the following
order:
IDE CD-ROM drive
Onboard SCSI controllers, Channel 1 then Channel 2
PCI slots 1–6
ISA slots 1 and 2
CAUTION
Changing some settings might cause your server
to operate improperly. It is important for you to
read carefully and understand the information
about BIOS setup in your System Reference
before attempting to modify the server's factory
settings.
DIGITAL Server 3220/3220R Series