Johnson Controls DT-9100-8104 Installationsdatenblatt Seite 9

Downloaded from www.Manualslib.com
Table 2: Dedicated Areas of the Display Screen
Area
Name of Display
Configuration
Time
More . . .
ALARM: Most Recent Alarm
Total: # Alarms
The Keypad
Table 3 describes the keypad keys and symbols, and Table 4 describes
the LED indicator located in the center of the keypad.
Table 3: Keypad Keys
Name
Up / Down
Page Up /
Page Down
Plus / Minus
Escape
Enter
Table 4: Keypad Indicator
Name
Alarm
Indicator
manuals search engine
Description
The name of the display configuration that the
DX LCD Display is currently using. You define the
name when you create the display configuration in
the GX-9100 software configuration tool.
The current time in the connected DX controller in
either 12 or 24 hour format, as defined in the display
configuration.
More is displayed on the next to last line of the
display if there are more pages of data associated
with the current function. Use the
(Page Down) key to display the next or previous
page.
The active alarm that occurred most recently and its
status.
The number of points that are currently in an alarm
state.
Symbol Description
These keys allow you to move between lines on a
page, for example to move the selection bar though
different items in a menu.
These keys allow you to scroll between pages if
more than one screen of information is available for
the selected function. This is indicated by the
prompt "More..." in the bottom right hand corner of
the screen
These keys allow values to be changed (increased
or decreased) while in edit mode. If either of the
keys is held down, then the auto-repeat function
allows you to obtain the value you require without
having to use multiple keystrokes.
This key is used to leave or abort a menu/sub-menu
esc
or adjust/command procedure
The enter key is used to confirm an action, for
example when choosing a menu option or
commanding/adjusting a value.
Symbol Description
In addition to the audible alarm, a red LED
! positioned above this symbol in the center of the
keyboard membrane indicates whether alarms are
present in the monitored system, as follows:
Flashing At least one unacknowledged alarm.
Steady On Alarms are present but all have been
acknowledged.
Off No alarms.
Installation Guide—DX LCD Display
(Page Up) or
9