Johnson Controls DT-9100-8104 Installationsdatenblatt Seite 3

Wall Mounting
Downloaded from www.Manualslib.com
Note: If the panel thickness is greater than 5 mm / 0.19 in., then
remove the flap on the back of the display covering the
terminals (see Figure 6) prior to mounting the display.
See Figure 1:
2. Insert the DX LCD Display into the cutout, as indicated by ➀ in
Figure 1.
3. From the rear of the panel, insert the locking tabs supplied with the
panel mounting kit into the corresponding slots in the sides and
back of the DX LCD Display, as indicated by ➁ in Figure 2.
See Figure 2:
4. Secure the DX LCD Display in the panel by tightening the screws
of the locking tabs, as indicated by ➂ in Figure 2.
5. From the rear of the panel, connect the serial cable between the
DX controller and the display unit, and connect the power supply
to the display, as described under Cabling of Permanently
Mounted Device later in this guide.
A separately available wall mounting kit
(Ordering Code: DT-9100-8902) is required to mount the DX LCD
Display on a wall. To mount the DX LCD Display on a wall:
1. Drill appropriate holes for the wall mounting bracket using the
dimensions shown in Figure 3.
See Figure 3:
2. Attach the wall mounting bracket to the wall using the screws
provided in the wall mounting kit, as shown in Figure 3.
3. Connect the serial cable and power supply to the display, as
described under Cabling of Permanently Mounted Device later in
this guide.
4. Place the DX LCD Display on the bracket, as indicated by ➀ in
Figure 4.
See Figure 4:
Note: The springs of the bracket fit into the rounded cavities in the
back of the display. Make sure that the slots in the bracket and
the slots in the sides of the display unit are aligned.
5. Secure the DX LCD Display to the bracket by inserting the locking
tabs supplied with the wall mounting kit into the corresponding
slots at the sides of the DX LCD Display, as indicated by ➁ and ➂
in Figure 4.
Note: Apply a slight pressure on the front of the display against the
springs of the bracket while inserting the tabs. Make sure to
push the tabs all the way in so that they pass through the
bracket and re-enter the second slot in the back of the display
unit.
manuals search engine
Panel Mounting Dimensions
Securing the DX LCD Display in the Panel
Wall Mounting Bracket
Securing the DX LCD Display to the Wall
Installation Guide—DX LCD Display 3