Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Power-Cord Caution - Onix A-55 MKI Bedienungsanleitung

Vollverstärker
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Thank you for purchasing ONIX Electronics. With sincere appreciation, we suggest you to read this User's Manual
thoroughly before operation and keep the Manual properly for further reference. .

INSTALLATION

Install the unit in a well ventilated place and do not expose
it to high temperatures or humidity, nor any heat sources
such as heaters or radiators. Be sure to leave space around
the unit for ventilation to improve heat radiation (at least
30 cm at top, 10 cm at rear, and 20 cm at each side). If there
is not enough space is provided between the unit and walls
or other equipment, heat will build up inside, inter fering with per formance or causing malfunctions.
CONNECTIONS
Before making or changing the connections, switch o the power in order to prevent damaging the product.
To connect the speakers, always check the correct polarity (red +) (black -) to avoid damaging them irreparably.
CONNECTING THE PIN-RCA CORDS
1
Left channel
3
White plug
Connect the white plug 3 to the L (left) channel 1,
and the red plug 4 to the R (right) channel 2.
Be sure to push the plugs securely.
MAINTENANCE OF EXTERNAL SURFACES
Remove dust and dirt with a clean, dry cloth.
Never use solvents, gasoline, insecticide sprays and other chemicals on or near the equipment because they can
corrode the surfaces.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short circuit or electric shock.
The ampli er is equipped with lters for the suppression of radio interference in accordance with EEC regulation
Downloaded from
www.Manualslib.com
L
2
Right channel
R
4
Red plug
manuals search engine
USER'S GUIDE
CONNECTING THE SPEAKER CORDS
2.
1
1. Strip o the vinyl covering and twist the tip of
the wire core.
2. Loosen the knob and insert the wire core into
the terminal hole.
3. Tighten the knob to x the wire core in place.
10mm
1.
Twist the wire core.
3.
2
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis