SUESS Medizin-Technik METRONIK BL-6 Compact Gebrauchsanweisung Seite 13

Gebrauchsanweisung
Guidance and manufacturer's declaration – electromagnetic emissions
The METRONIK BL-6 is intended for use in the electromagnetic environment specified below. The
customer or the user of the BL-6 Monitor should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
Power
frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
Note: U is the a.c. mains voltage prior to application of the test level
T
13
IEC 60601 Compliance
test level level
± 6 kV contact
± 8 kV air
±2 kV ±1 kV
for power supply lines
±1 kV for
input/output lines
± 1 kV differential mode
± 2 kV common mode
<5 % U (>95 % dip in U
T
for 0,5 cycle
40 % U (60 % dip in U
T
for 5 cycles
70 % U (30 % dip in U
T
for 25 cycles
<5 % U (>95 % dip in U
T
for 5 sec
3 A/m
Electromagnetic environment -
guidance
The Floors should be made of wood,
concrete or ceramic tiles. If floors are
covered with synthetic material, the
relative humidity should be at least 30
%.
Mains power quality should equal the
quality of a typical commercial or
hospital environment.
) Mains power quality should equal the
T
quality of a typical commercial or
) hospital environment. If the user of
T
the BL- 6 Monitor requires continuous
) operation, even during power
T
blackouts, it is recommended that the
) BL-6 Monitor is powered by an
T
uninterruptible power supply.
Power frequency magnetic fields
should be at levels that are
characteristic of a typical location in a
typical commercial or hospital
environment.
METRONIK Blutdruckmonitor BL-6