Troubleshooting Guide - SAKOBS GC-1032 Bedienungsanleitung

TROUBLESHOOTING GUIDE:

Problem
The detector displays or sounds
without detecting any target
The detector sounds false signals.
The detector does not detect anything
The detector does not function.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT OUR
CUSTOMER SERVICE FIRST, YOU CAN REACH US AT service@sakobs.cc.
OUR PROFESSIONAL REPRESENTATIVES AND ENGINEERS ARE HERE
READY TO HELP.
Warranty & Customer Service
Please first read all instructions before attempting to use this product.
Register your product via Email to service@sakobs.cc with your order ID to get EXTRA 1
YEAR Warranty.
Are you a happy customer? The Sakobs metal detector comes with 365 days Warranty that
begins on the date of purchase. If you would like a replacement or refund, please contact us
at service@sakobs.cc for a faster solution. Our customer service teams guarantee hassle-free
solutions to any issue you might have
within 24 hours.
service@sakobs.cc
60 days money back guarantee
1 Year Replacement Warranty
Lifetime technical support
Reason
The detector may receive interference
and false signal from broadcast a
ntenna and other electronic lines.
The humidity of environment may be
extremely high.
Sensitivity set too high/ environmental
electromagnetic interference.
Sweeping the detector's search coil
too fast or at wrong angle.
Using 2 detectors in close proximity
Maybe the target is oxidized
Sensitivity set too low
Target range is eliminated
Search coil is not parallel to the
ground
Five-pin cable not connected well
Dead battery
Suggestion
1.Change searching place
2.Wait for some time to check again
1.Reduce sensitivity
2.Sweep the search coil more slowly
and hold the detector correctly.
3.Keep two detectors at least 6 meters
(20') apart
1.Increase sensitivity
2.Recover all target range
3.Adjust the search coil angel to
1.Re-plug it properly
2.Replace batteries