Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Unscrew the outside FADER PLATE SCREWS (B). D
2. Carefully lift the fader and unplug the CABLE (D).
3. Plug the new fader into the cable and place it back in
mixer.
4. Screw the fader to the mixer.
5. PUNCH IN: The PUNCH IN BUTTONS (14,26) allow you to add a
channel' s Signal to the mix when the crossfader is set to the opposite
channel.
6. OUTPUT CONTROL SECTION: The level of the MASTER OUTPUT (28)
is controlled by the MASTER (25) control. The BALANCE (24) control
will allow the MASTER OUTPUT Signal to be balanced between the left
and right speakers. The BOOTH (23) control adjusts the level of the
BOOTH OUTPUT (29). HINT: The booth OUTPUT is used by some DJs
to run monitor speakers in their DJ booth. You tan also use it as a
7. TALKOVER SECTION: The purpose of the talkover section is to allow
the music. The MIC/TALKOVER SVVITCH (2) has three settings. When
the MICTTALKOVER SWITCH (2) is in the bottom Position, the mit and
talkover are both off. When the MICITALKOVER SWITCH (2) is in the
talkover is off. When the MICITALKOVER SWITCH (2) is in the top
Position, the mit and talkover will be on and the volume of all sources
except the Mit input are lowered by 16 dB. LEVEL (4) controls the
level of the MIC.
8. CUE SECTION: By connecting a set of headphones to the HEADPHONE
(22) jack, you tan monitor either channel or both together. Select the
CHANNEL 1 by sliding the CUE SLIDER (16) control to the left or
CHANNEL 2 by sliding the CUE SLIDER (16) control to the right. Use
effecting the Overall mix. Use the CUE SPLIT (15) button to Split the
earphone and CHANNEL 2 will be heard in the other earphone.
9. DISPLAY: The dual function DISPLAY (7) indicates either the MASTER
OUTPUT (28,31) left and right levels or the CHANNEL 1 and
CHANNEL 2 input levels. You tan choose the Option you want by
pressing the DISPLAY (6) button.
Downloaded from
www.Manualslib.com
c 0
manuals search engine
not
O
INPUTS:
the
DJ Mit ................................................... .1.5mV 2Kohm balancec
Phono ...................................... . ................................. .3mV 47Kohr
Line.. .....................................................................
OUTPUTS:
GENERAL:
Low (Channels 1 - 2) ........................................................
Mid (Channels 1 - 2) .........................................................
High (Channels 1 - 2) ..................................................... + 12dBI-32 di
Gain (Channels 1 - 2) ........................................................... 0 to -2od:
Frequency Response ....................................
Distortion ................................................................................
Talkover Attenuation. .............................................................
Headphone Impedance. ........................................................ 16ohn
Power Source.. ...........................................
Dimensions.. ............... 10" ~ x 3S" h x 14"d (254 x 89 x 305 mrr
Weight.. ......................................................................... .6.6 Ibs. (3 kg
Page 4
150 mV 27Kohr
0 dB 1V 4000hr
Max.. ........................... .24V Peak to Pea+
225mV 5Kohr
0.02"
Werbung
