Setting Up; Preparing The Surface; Inspect The Machine Before Starting - P.Lindberg 9063195 Original Bedienungsanleitung

Setting up

1. Localise the high-pressure outlet hose on the high-pressure cleaner and ensure that it
is securely connected to the patio cleaner's outlet. Connect the other end of the high-
pressure hose to the pistol on the patio cleaner.
2. Connect one end of the water supply hose to the patio cleaner and the other end to
the high-pressure cleaner.

Preparing the surface

1. Remove all loose material from the area that is to be cleaned.
2. Never attempt to clean areas that have protruding items. If the equipment comes into
contact with obstacles, it may damage the equipment. Should the equipment come
into contact and the machine consequently vibrates when operated, stop the work
and replace the rotary arm.
CAUTION
Risk of damaging the machine!!
Never use the equipment if it starts to vibrate! Switch
off the machine and tighten the rotary arm, bolts
and joints.

Inspect the machine before starting

1. Before use, inspect the patio cleaner. Tighten the rotary
arm, bolts and joints as required.
2. Ensure that all joints are tightened securely. Set the water
supply to ON (but do not start the high-pressure cleaner!).
3. Check to ensure that the hoses are free of kinks, fissures, or
leaks. If any faults are detected, then do not use the hose! Replace the hose before
starting.
4. Release the pistol and press the trigger. Water will now start to flow from the patio
cleaner's nozzles. Check that the nozzles are not blocked and that the spray pattern is
not irregular. Replace the nozzles if there is a problem.
5. Ensure that damaged parts are replaced, and any mechanical problems are corrected
before taking the equipment into use.
P. Lindberg A/S
Tel.: +45 70212626
9
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9063195 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk