Laserworld Club Serie Bedienungsanleitung Seite 11

Manual: Club Series MKII
ILDA control: Connect your device („ILDA IN") via an ILDA cable to an interface / con-
troller. Use a laser control software, to run the device. Use „ILDA OUT" to connect it to
another device. In ILDA mode all DIP switches should be switched off.
Master-Slave-Mode: To use the daisy chain / Master-Slave-Mode connect two (or more)
laser projectors of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Choose stand-alone
or sound-to-light-
mode at the master
projector
(see above)
6. To turn off the device switch it off („OFF"), switch the key to „OFF" and disconnect the
power cable from the mains.
page 11 / 33
DMX cable Slave projector
DMX setting at the
slave projector: