Herunterladen Inhalt Inhalt Diese Seite drucken

Batteries & Charging - Jobe E-DUNA SUP Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The battery will arrive with half a charge, so before use it MUST be charged using the included charger according
to the directions included. SEE: CHARGING BATTERY. The battery can be transported in the Drive housing, as
long as the battery is not connected to the Drive.
WARNING
During transport and storage the battery MUST NEVER be exposed to temperatures above 120 °F
(50 °C ), as this will reduce the battery's lifespan and it may damage it permanently.
DO NOT LEAVE the BATTERY IN YOUR VEHICLE ON A SUNNY DAY!
WARNING
DO NOT transport the chargers together with wet components.
CHARGING THE [Drive] BATTERY
You will need to charge 2 batteries to start using the board: 1) the battery in the remote control ring, and 2)
the battery for the Drive.
1) Use the charging cable to charge the battery in the remote control
2) With the same charger, charge the battery for the Drive
NOTE: The XX volt charger is suitable for power outlet voltage ranges of 110 VAC to 240 VAC
(therefore universal, and compensates for differences in voltage automatically).
WARNING
You MUST be physically present while the battery is charging . DO NOT leave a charging battery
unattended. Disconnect power immediately if battery overheats or other signs of failure occur, including if the
battery emits an unusual smell, feels hot, changes color or shape, or appears abnormal in any other way.
1
Charge the battery with the included charger in a completely dry environment. Make sure the battery is comple-
tely dry when charging. Attach the battery to the charger, and plug it into an electrical outlet/socket. The order
you connect them with the charger is not important. Charging will commence after a few seconds. The two-color
LED shows you the status:
- red: charging
- green: charging completed
WARNING
If the LED is blinking, there is an error and you MUST stop charging immediately (disconnect). The
cause could be a battery failure (too drained, too moist, overheated) or an issue with the connector or cables.
Charging is automatic. The battery normally will reach a full charge in under 3 hours. However, charging time may
vary based on battery level at the beginning of the charge. Once the battery is charged disconnect it from the
charger.
BATTERIES
1
2
8
2

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Jobe E-DUNA SUP

Inhaltsverzeichnis