Marantz professional RHA6 Benutzerhandbuch Seite 5

Through the Aux inputs, you can use the six channels of RHA6 independently to give individual mixes to six
different musicians. Connect the Aux Sends or Subgroup outputs directly to the Aux input of RHA6. Then
rotate the balance control on your RHA6 fully to the left. This will route only the Aux In signal to the
headphones.
Using Multiple Headphones on the Same Channel
Each channel provides three headphone outputs. These jacks are all connected in parallel. For best results,
please note the impedance information:
•
When connecting one headphone to each channel, the minimum impedance of the headphone should
be 100 ohms.
•
When connecting two headphones to each channel, the minimum impedance of each headphone
should be 200 ohms.
•
When connecting three headphones to each channel, the minimum impedance of each headphone
should be 300 ohms.
Aux
Aux
Send 2
Send 1
Aux
Aux
Send 3
Send 4
Aux Aux
Send 5 Send 6
5