Hama S2110 Bedienungsanleitung Seite 9

Operation
1. Hotkey Port Selection
All hotkey port switches begin with tapping the Ctrl key twice.
[Ctrl] [Ctrl]
2. Invokes Auto Scan Mode
Starts Auto Scan. Press and release the [Left Shift] key, and then press the [Right Shift] key.
[Left Shift] [Right Shift]
Scan Interval
Sets the Auto Scan interval to n second intervals - where n is a number from 1 – 4.
[Left shift] [Right shift] [n]
Note: The n stands for the number of seconds that the focus dwells on a port before switching to the other one.
Replace the n with a number between 1 and 4 when entering this hotkey combination. (See the table, below.)
Scan Interval Table
n
1
2
3
4
Terminates the hotkey mode and the automatic switch-over
[Esc] or [space bar]
Hotkey key confi guration
When you have activated the hotkey mode [Strg] + [F12], press one of the following buttons to invoke the corresponding function:
Key
[F1]
[F2]
[F3]
[F4]
R > [Enter]
8
00052349bda.indd Abs2:8 00052349bda.indd Abs2:8
Downloaded from www.Manualslib.com
Scan Interval
3 Sec.
5 Sec. (default)
10 Sec.
20 Sec.
Operation
Recognizes and stores the hardware sided keyboard environment.
Uses the Mac compatible keyboard environment.
Uses the Sun compatible keyboard environment.
Prints out the current assignment for hotkeys, keyboard platforms
and language setting.
Resets the hotkey settings to the standard values.
manuals search engine
10.07.2008 13:52:10 Uhr 10.07.2008 13:52:10 Uhr