Installation; Maintenance - Spectroline uVision Serie Handbuch

INSTALLATION

Lamp-Ballasted Models (Ceiling Mount)
•Select a location within proximity to an electrical outlet.
•Suspend the lamp assembly from a suitable ceiling mount. Connect a chain to the ceiling
mount. Next, fasten the chain to the eyebolts located on the topside of the unit. Make
certain the unit is balanced.
OPERATION
• Connect the primary cord to a power outlet that complies with the electrical requirements
listed on the lamp.
• Pull the cord out to the desired length and stop. If the cord does not hold, continue to
pull the cord slowly, stopping every 4 inches (10 cm). This will engage the lock. To retract,
pull the cord out 2 to 4 inches (5 to 10 cm) and guide the cord slowly back into the reel.
• Do not pull hard on the cord when it is fully extended to 50 feet (15.2 m). This will cause
retracting spring to malfunction.
• Do not allow the cord to fly unrestricted back into the reel.

MAINTENANCE

• Remove dirt and grime as soon as it accumulates on the reel case. Wipe clean with a
dampened cloth. Do not use solvents such as gasoline, turpentine, etc., to clean the unit.
• Keep the cord clean to ensure the smoothest automatic retraction. Pull the cord to its
full length and allow it to retract through a clean, dampened cloth. Pull out the full length
again and allow it to retract through a clean, dry cloth sprinkled with talcum powder.
GENERAL SAFETY INFORMATION
• This unit should be used indoors. Do not use near potentially dangerous locations such
as flammable or explosive atmospheres or near water.
• Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole
receptacles that accept the unit's plug.
• Disconnect the unit from the power supply before servicing or inspecting it for any reason.
WORK AREA SAFETY
Keep work area clean, dry, free of clutter, and well lit. Cluttered, wet, or dark work areas can
result in injury. Using the tool in confined work areas may put you dangerously close to other
cutting tools and rotating parts. Be aware of all power lines, electrical circuits, water pipes,
and other mechanical hazards in your work area. Some of these hazards may be below the
work surface hidden from your view and may cause personal harm or property damage if
unintentionally contacted.
ELECTRICAL GROUNDING
This reel must be grounded to protect the operator from electrical shock. The plug MUST be
plugged into a matching receptacle that is properly installed and grounded in accordance
with ALL local codes and ordinances. DO NOT MODIFY THE PLUG PROVIDED. If it will not
fit the receptacle, have the proper receptacle installed by a qualified electrician. CHECK with
a qualified electrician or service person if you do not completely understand the grounding
instructions, or if you are not sure the tool is properly grounded.
CORD REEL INSTRUCTIONS
6