Environmental Specifications; Limited Warranty - Spectroline uVision Serie Handbuch

DISASSEMBLING THE FILTER PROTECTOR FOR MAINTENACE
The outer rubber cover/filter holder may be removed periodically to clean the Borofloat
glass filter. To disassemble the Borofloat
rubber cover/filter holder. Peel the rubber cover/filter holder toward the front portion of the
lamp.
The Borofloat glass filter will remain inside the protector. To remove the Borofloat
®
filter, peel around the edge of the rubber cover/filter holder and push the glass filter out.
To replace or reinsert the Borofloat
Borofloat glass filter into the channel of the rubber cover/filter holder. Manipulate the rubber
®
cover around the filter. Ensure the glass filter is evenly seated.
REPLACING THE UV LENSES
The UV-A lenses (UL-110) covering the three UV-A LEDs must be replaced over time. They
will solarize (become cloudy and yellow) from repeated use. A set of detailed instructions
come with the replacement UV-A lenses (UL-110). See Replacement Parts section and
contact Customer Service for more details.

ENVIRONMENTAL SPECIFICATIONS

The uVision™ series lamps are designed to be safe under the following conditions:
• For Indoor/Outdoor Use (dustproof and protected against jets of water);
• Temperature 41°F to 122°F (5°C to 50°C);
• Mains supply voltage fluctuations not to exceed ±10% of the nominal voltage;

LIMITED WARRANTY

The warranty policy for the uVision™ lamp is provided on the Certificate of Limited Warranty
enclosed separately with each unit. NOTE: For assistance of any kind, please contact the
Customer Service Department at Spectro-UV. Provide the model, the serial number of the
unit, and the date of purchase. The unit's serialization information is located (1) on the
packaging the unit is shipped in, (2) engraved on the unit's handle, and (3) labeled on the
reverse side of the unit's back plate.
Orange = Power on, battery good
Blink Orange and Red = Low Battery; time left approx. 10 – 15 mins
Red = Dead Battery, Approx. 5 minutes or less remaining
Shut Down
Filter Protector (FP-600), first remove the front
®
glass filter into the rubber cover/filter holder, slide the
®
BATTERY LED INDICATOR STATUS
3
®
glass
®