Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Key Switch SKS
1). The SKS key switch can be installed outside, close to the gate at the height of about 100 cm, so that it could be
used by most people. Decide the installation position first. See Figure 1 .
2). Remove the round cover (A) by gently prying it out with a thin screwdriver. See Figure 2 .
3). Unscrew the two screws beside the lock. See Figure 3 .
4). Turn the key and separate the bottom of the shell with the lock body. See Figure 4 .
Figure 1
Figure 3
5). Breach the three holes at the bottom and mark the points by the holes as reference.
6). Drill the holes in the wall and fix the bottom to the wall with the three screws. See Figure 5 .
7). Connect the electric wires to the terminals as shown in Figure 6 , and it's not required to distinguish any
polarity. The terminals can be removed for connecting the wires easily.
8). Turn the key and insert the shell on the bottom. Turn the key back to the center position and the cover will be
fixed to the bottom.
9). Tighten the lock body with the two screws and insert the round cover by pressing it to attach to the whole unit.
Figure 5
Figure 2
A
Figure 4
Figure 6
Werbung
