Kettler DINO SM Plus Montageanleitung Seite 4

Replace worn or damaged parts immediatlely and ensure that the product is not used again until this has
been done. If any parts require replacement, use only original spares manufactured by KETTLER.
This product is suitable for children between 2 - 5 years with a body height from 90 - 115 cm
This child's wheeled toy conforms to the stipulated safety regulations European standard EN 71-1/-2/-3
(„Safety regulations for childrens toys"; max. weight of user: 50 kg). Incorrect repairs or alterations (removal
of original parts or addition of other parts etc.) may be a source of danger to the user.
Use of the Toy
Ensure that the toy vehicle is not used until it has been properly assembled and checked by an adult person.
For safety reasons, it should never be used close to slopes, busy roads, railway crossings, rivers, ponds etc.
Please bear in mind that there is always a danger of children injuring themselves whilst using swings, climb-
ing frames, toy vehicles or similar equipment.
When using the toy vehicle, the user should always wear strong shoes.
Instruct your child how to use the vehicle correctly and draw attention to possible sources of danger.
When children are at play, situations may arise which cannot be predicted by the manufacturer and for which
he cannot be held responsible.
Although dangerous situations are unlikely to occur if the toy is used correctly, children at play should, if possi-
ble, be supervised.
Before use, always check all screws and plug-in connections as well as respective safety devices fit correctly.
Never use corrosive or abrasive substances to clean the toy. Never use substances which may cause pollution
of the environment.
For models with push bars: Always ensure that the push bar fits correctly in the adaptor, and locks. Do not hang
any weights on the bar! The vehicle may tip over, and your child may be hurt. The push bar is intended for
adult use only, do not pass responsibility for children on to other children. For free play time take the push bar
off for safety reasons.
Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every two or three months.
Assembly of the toy vehicle
The toy vehicle must be assembled carefully by an adult person. Study the assembly instructions carefully befo-
re beginning work. Assemble the vehicle in the exact sequence shown by the letters in the diagrams. This is
essential for the safe function and use of the scooter
Please note that there is always a danger of injury when working with tools or doing manual work. Therefore
please be careful when assembling this machine.
Ensure that your working area is free of possible sources of danger, for example don't leave any tools lying
around. Always dispose packaging material in such a way that it may not cause any danger. There is always
a risk of suffocation if children play with plastic bags!
Bolt all the parts together loosely at first, and check that they have been assembled correctly. Tighten the lock-
nuts by hand until resistance is felt, then use spanner to finally tighten nuts completely against
resistance (locking device). Then check that all screw connections have been tightened firmly. Attention:
once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed),
and must be replaced.
Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary.
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).
When ordering spare parts, always state the full article number, spare-partnumber, the quantity required and
the serial number of the product.
Example order: Art. no. 08154-800 / spare-part no. 10111018 / 2 piece / s/n ...
Important: spare part prices do not include fastening material; if fastening material (bolts, nuts, washers etc.)
is required, this should be clearly stated on the order by adding the words „with fastening material".
KETTLER (GB) Ltd. · KETTLER House, Merse Road · North Moons Moat · Redditch, Worcestershire · B 98 9 HL ·
Great Britain
KETTLER International Inc. · P. O. Box 2747 · Virginia Beach · VA 23450-2747 USA
http://www.kettler.de
4