Gaoke Strend pro Gebrauchsanweisung Seite 32

cables increase the risk of electric shock.
- Never work with tools that have a damaged power cable or fork or that were dropped to the ground
and damaged in any way.
- When using power tools outdoors, use an extension cord suitable for outdoor use. Using a cord
suitable for outdoor use reduces the risk of electric shock
- If you use power tools in damp areas, use a RCD-protected power supply. Use of the RCD reduces
the risk of electric shock. The term "residual current device (RCD)" may be replaced by "ground-fault
circuit interrupter (GFCI)" or "earth leakage circuit breaker (ELCB)".
- Hold the power tool only by its insulated gripping surfaces, as cutting or drilling accessories may
come into contact with hidden wires or their own cord during operation.
3) PERSONAL SAFETY
- When using power tools, be alert and pay a particular attention to the work you are doing. Focus on
your work. Do not operate power tools if you are tired or under the influence of drugs, alcohol or
medication. Even a momentary inattention while using power tools can result in serious personal
injury. When working with power tools, do not eat, drink or smoke.
- Use safety clothing. Always wear eye protection. Use protective equipment appropriate to the type
of work you are doing. Protective equipment such as respirator, non-skid safety shoes, headgear or
hearing protection, used in accordance with working conditions, reduce the risk of personal injury.
- Avoid unintentionally turning on the power tools. Do not carry the power tool connected into mains
with your finger on the switch or trigger. Make sure the switch or trigger is in the "off" position before
connecting to the power supply. Carrying the power tool with a finger on the switch or connecting
the power plug into the socket with the switch turned on can cause serious injury.
- Before you turn on the power tool, remove all adjusting keys and tools. An adjusting key or tool that
remains attached to the rotating part of the power tool may cause personal injury.
- Always maintain a stable posture and balance. Only work in areas you can safely reach. Never
overestimate your own strength. Do not use the power tool if you are tired.
- Wear suitable clothes. Use safety clothes. Do not wear loose clothing or jewelry. Make sure that
your hair, clothing, gloves or any other part of your body does not get too close to the rotating or hot
parts of the power tool.
- Connect the power tool to dust extraction. If the power tool can be connected to dust collection or
extraction equipment, make sure it is properly connected and used. The use of such equipment may
reduce risks due to dust.
- Fix the workpiece firmly. Use a joiner clamp or vice to fix the workpiece to be machined.
- Do not use any tools if you are under the influence of alcohol, drugs, medicines or other narcotic or
addictive substances.) - The machine is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person responsible
for their safety. Children must be supervised to ensure that they do not play with the machine.
4) USE AND MAINTENANCE OF THE POWER TOOL
- In case of any problem during operation, before any cleaning or maintenance work, every time you
move or stop using the power tool, disconnect it from the power supply/mains! Never work with the
power tool if it is damaged in any way.
- If the power tool starts to produce abnormal sound or smell, stop working immediately.
- Do not overload the power tool. The power tool will work better and safer if you work with it at the
speed (rpm) it was designed for. Use the right tool for the job. A suitable tool will perform the work
for which it was made well and safely.
- Do not use power tools that cannot be safely turned on and off with its control switch. Using such a