Battery Pack; Battery Door; A/C Power Adapter; Pole Clamp - Kangaroo ePump Bedienungsanleitung

Battery Pack

See Section VIII for full instructions on replacing battery pack. During long-term non-usage or storage (greater than 9 months) of
the pump, battery discharge and deactivation may tend to occur. It is recommended that the battery be disconnected during this
time. The battery may need to be charged and discharged several times to restore optimal capacity.

Battery Door

To replace battery door, see Figure 36 and do the following:
1. Align the battery door hinges with the long hinge pins.
2. Snap the hinges onto the hinge pins.
3. Screw down the door to hold in place.

A/C Power Adapter

See Section IV for initial setup, including A/C Power Adapter attachment.

Pole Clamp

See Section IV for initial setup, including attachment of the pole clamp to the pump.
Section XIII – Service Part Numbers
To place an order for parts, or if technical assistance is required, call customer service.
The Kangaroo™ ePump™ enteral feed and flush pump contains a limited number of serviceable parts, Figure 37. User maintenance is
to be performed only by appropriately qualified technical personnel.
Kangaroo™ ePump™:
1
US:
International:
Main Door:
2
(Blue transparent door)
Battery Pack:
3
Battery Door:
4
(with screw)
A/C Power
Adapter:
Pole Clamp:
5
Electrical Plugs
(Set of 4)
Kangaroo™ ePump™ Enteral Feed and Flush Pump with Pole Clamp
• 382400
• 482400
• F31877WT
2
• 1041411
• F31878WT
• 382491(5)
• 382492
Figure 37. User Serviceable Parts.
• 382493
Figure 36. Battery Door Replacement.
1
35
5
3
4
Table of Contents