Preparing For Use - Wellcare WE-167UBAHD Gebrauchsanleitung

PREPARING FOR USE

(please see fig.B for demonstration of single size)
1. Place the underblanket (8) flat on the mattress,
make sure it is without any folds or ruck-up.
2. The area with dense 4D DWF holes is designed
to provide additional warmth for feet, please lay
this part on the foot end of your mattress.
3. The head area does not need to be heated.
4. Join the detachable plug-in connector (6) to the
connection box (7). (See fig. B) (For double-size
blanket, please remember to couple both plug-in
connectors to the connection boxes)
5. Cover the electric underblanket (8) and the
mattress with the sheet, make sure the blanket is
completely flat and the controller(s) (2-1, 2-2) is
not covered by the sheet, pillow or any objects.
6. Plug the mains cable (1) to the socket.
7. The blanket(8) should be covered by a duvet, for
example, otherwise there will be a high loss of
heat and the blanket cannot warm up properly.
Unplug the appliance from the wall socket when
it is no longer in use.
SWITCHING ON
Before each time you use the electric underblanket
(8), please make sure it is not bundled, folded or
creased before it is switched on.
Connect the electric blanket (8) only to 230VAC.
Switch on the underblanket by using the hand-
operated slide switch(4) and there will be 3 times
EN
13