Regin ED-T43L-V Installationsanleitung

EN INSTRUCTION
ED-T43L-V
IN20031 REV. C, 2020-12-04
C C a a u u t t i i o o n n ! ! Read and understand the instruction before using the product.
C C a a u u t t i i o o n n ! ! Ensure that the installation complies with local safety
regulations.
C C a a u u t t i i o o n n ! ! Before installation or maintenance, the power supply should first
be disconnected. Installation or maintenance of this unit should only be
carried out by qualified personnel. The manufacturer is not responsible
for any eventual damage or injury caused by inadequate skills during instal-
lation, or through removal of or deactivation of any security devices.
Function
ED-T43L-V is a user-friendly touch display suitable for all types of
indoor environments. The users have access to different settings
depending on the assigned access rights.
Technical Data
General data
Supply voltage 24 V DC (22...26 V DC)
Power consumption 1.2 VA
Protection class IP20
Storage temperature -20...70 °C
Ambient temperature 0...45 °C
Ambient humidity 5...95 % rH
Dimensions, external (WxHxD) 144 x 96 x 14 mm
Display type Resistive touch
Touch panel 4.3" TFT-display
Communication data
Communication ports 1
Port type RS485
Default protocol Modbus
Supported protocols Modbus
Communication speed 19200 bps
Parity N
Stop bits 1
Installation
The display is starting up after connecting the power. Wait a few seconds
for the home screen to be shown.
Log in as described under Handling.
Wiring
The display cable is connected to the display port on the Corrigo
controller via a 4P4C modular contact. The cable is ordered separately
and is available in two versions (3 and 10 m). A user made cable can be
made according to the wiring diagram in Figure 1. The maximum cable
length is 100 m.
4P4C contact ED-T43L-V
+C
1
2 G0
A
3
B
4
Figure 1 Cable connection (Colour code EDSP-Kx: 1=Black, 2=White, 3=Yellow, 4=
Brown)
Settings
The display reflects the controller configuration. The configuration can
be changed with the free software Application tool (see www.
ED-T43L-V
regincontrols.com). Values such as setpoints, time channels, times etc
are changed via the display as described under Handling.
Handling
Getting started
1. Press
2. Log in with
3. Go to Account settings and use the navigation buttons to go to page 3
4. Select the functions that should be shown in the display
5. If a different language is required, navigate to page 2 and change it
under Language
Log in access code
The display uses the same access code that is used in the controller.
Navigation
Navigation is done using four main menu buttons.
Menu button Description
This is the home screen. Here the user gets an overview of
the actual values and setpoints.
In this menu fan settings are made:
– Boost fan
– Extended run
– Stop
Time channels can be set and modified in this menu (if they
are configured in the controller).
Different settings can be viewed or modified under this menu,
e.g.:
– Account settings, such as language settings and pin codes
– Home screen content
– Setpoints
– Date and time
– Status
– Configurations related to CLOUDigo, TCP/IP and address
Standard buttons that are used in the different views are shown below:
1