Technical Data; Special Safety Instructions - rawlink 56697 Gebrauchsanweisung

HYDRAULIC JACK
Introduction
To get the most out of your new hydraulic
jack, please read through these instructions
before use. We also recommend that you
keep these instructions so you can refer to
them at a later date.

Technical data

Lifting capacity:
Lifting height:
(469 mm when using an extender)

Special safety instructions

• Read and understand all warnings and
instructions before use.
• This jack is designed only for lifting.
Immediately after the lift, the load must
be supported by suitable equipment.
• Lift only on areas of the vehicle as
specifi ed by the vehicle manufacturer.
• Centre the load on the saddle before
lifting the load.
• Some vehicles require an adapter in order
for them to be lifted using a jack. Follow
the instructions in the vehicle manual.
• You must not make any changes to the
hydraulic jack.
• Only use accessories, adapters and
securing parts recommended by the
manufacturer.
22
• Failure to comply with the instructions
may lead to personal injury and/or
material damage!
• If the hydraulic jack is overloaded, this
can lead to serious personal injury and
material damage. Do not lift weights
greater than the jack's lifting capacity.
• The hydraulic jack must only be used as a
lifting unit, never as an axle stand. Before
you commence any type of work under a
2.5 tonnes
raised vehicle or similar, you MUST have
85-381 mm suitable axle stands in place.
• The hydraulic jack must only be used on
a permanent, even and level surface.
• Always position the weight in the centre
of the jack saddle. If the weight is uneven,
the jack may become damaged or drop
the load.
• Never push or pull a vehicle which has
been lifted by the hydraulic jack.
• Always inspect the jack before use and
do not use it if there are cracks in the
welding joints, or if it is damaged in any
way.