Beper MATIX 50.971 Betriebsanleitung Seite 11

EN
Steam station Use instructions
USING YOUR STEAM STATION IRON
The appliance has two iron portions. You can use dry ironing or steam ironing. The details refer to the following:
Dry ironing
1. Put the iron on the thermal insulating cushion.
2. Connect the plug to wall outlet, together with one beep can be heard. And then press down the Power button,
the power indicator starts to illuminate.
3. Turn temperature dial to your desired setting, which is depended on the fabric of garment, and the temperature
indicator will illuminate. Refer to IRONING TIPS latter. The iron starts heating.
4. When the temperature indicator turns off, the selected temperature is reached. You now can start ironing.
WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
1. Grasp and press the water tank's handle to take out of the water tank, then open the filling aperture cap and
fill water into the water tank. You had better use purified water with less calcium particles. After it, close the filling
aperture cap. The max capacity of water tank is 1.2L, the water level shall not be exceeded the MAX mark.
2. Replace the detachable water tank properly.
3. Put the iron on the thermal insulating cushion.
4. Connect the plug to wall outlet, together with one beep can be heard. And then press down the Power button,
the power indicator starts to illuminate, also the low steam level regarded as defaulted one and its indicator will
flash. And you can select other steam level by pressing the steam level control button according to your requi-
rement. When being selected, its corresponding indicator will flash.Make sure that there is enough water in the
tank.
5. Turn temperature dial to your desired setting, which is depended on the fabric of garment, and temperature
indicator will illuminate. Refer to IRONING TIPS latter.
6. The water in the tank will be heated, after a few minutes, the temperature indicator will be extinguished, which
indicates the soleplate temperature has achieved the selected temperature. And when the indicator of selected
steam level has been changed flashing to illuminating, it indicates you can take out of the iron and iron the gar-
ment with steam by pressing the steam trigger of the iron.
Caution: 1) Do not touch hot soleplate at any time before cooling down!
2) Don't emit the steam directly to the people.
7. During operation, if there is less water in the tank, the lack of water indicator will be illuminated, following with
two beeps can be heard. At that time, you should refill the water tank through the filling aperture or move out of
the water tank to refill it. After it, press the reset button to reactivate the steam release function.
8. After finish ironing, press and hold the Power button for a while, following with one beep can be heard, and
the appliance will be turned off and all the indicators will be extinguished. Or you can put the iron the thermal
insulating cushion, if there is no steam sprayed out from the soleplate within 10 minutes, the appliance will be
turned off automatically. Remove the plug from the wall socket. But the soleplate is still hot, never touch it with
hand, place it on the thermal insulating cushion until it cools down completely.
CLEANING
Unplug the supply cord.
To clean the body of the appliance, simply use a moist cloth. Do not use solvents or detergents which may harm
the body material.
HOW TO STOCK YOUR STEAM STATION
Switch off the appliance by the button on 0 and unplug the supply cord.
Let the iron cool on the iron rest. Stock the steam station and pay attention that the supply cord does not touch
the hot parts.
Always stock the steam station on a stable surface and keep it away from children.
11