Battery Replacement - Waeco ST-8810 Bedienungsanleitung

_ST-8810.book Seite 15 Donnerstag, 2. Februar 2006 11:24 11
ST-8810
3.5 Laser pointer
To turn on the laser pointer, press the "Laser" key while pressing the "On/
Hold" key (Fig. 9).
Press the "Laser" key again to turn off the laser (Fig. 10).
Fig. 9
3.6 Measurement considerations
Hold the meter by its handle, point the IR sensor towards the object whose
temperature is to be measured. The meter automatically compensates for
temperature deviations from ambient temperature.
Keep in mind that it will take up to 30 minutes to adjust if wide ambient
temperatures have been measured. After measuring low temperatures and
before measuring high temperature, allow some time (at least several
minutes) for the cooling process of the IR sensor.
4

Battery replacement

If the battery power is not sufficient, the LCD will display a battery symbol to
indicate that a new 9 V battery is required (Fig. 11).
Fig. 11
Open the battery cover. Remove the battery from the meter and replace it
with a new 9 Volt battery. Close the battery cover.
Battery replacement
Fig 10
15