Cleaning; Maintenance/Light Emitting Diode/Thermal Safety Cut-Out - Deuba monzana DBHK010 Anleitung

21

CLEANING

NOTE: Allow the product to completely cool before handling or cleaning it.
1.Switch off and unplug from the power supply before cleaning.
2.Using a soft, moist cloth, with or without a mild soap solution, carefully clean
the exterior surface of the product.
3.Do not allow water or other liquids to run into the interior of the product, as
this could create a fire and/or electrical hazard.
4.We also recommend the periodic cleaning of this appliance by lightly running
a vacuum cleaner nozzle over the guards to remove any dust or dirt that may
have accumulated inside or on the unit.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they
may damage the surface finish of the plastic components.
Maintenance
Always disconnect from the power supply before attempting any
maintenance.
Light Emitting Diode
This fire is fitted with LED ( Light Emitting Diode) blubs in place of traditional
incandescent bulbs. These generate the same light levels as traditional bulbs,
but use a fraction of the energy consumed.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to prevent damage due
to overheating. This can happen if the heat outlet was restricted in any way.
The heater will switch on once the obstruction has been removed and the
heater has cooled. If the cut-out continues to operate intermittently, the heater
should be switched off and a service agent contacted
www.DeubaXXL.de