Declaration Of Conformity - Laica HYDROSMART Anleitungen Und Garantie

Instructions and guarantee
- To guarantee the best performance, the
working pressure should be between 0.20
and 0.35 MPa.
• Filter only cold running water from the domestic water
supply, with the filter properly assembled
• This device is NOT intended for professional use but
for domestic use only.
IMPORTANT NOTES FOR PRODUCT USE
• The HYDROSMART™ filter filters water, which IN
ANY CASE MUST BE DRINKABLE. Before use, verify
the water quality with the competent authority in the
area for informed use of the product.
• The Laica filtration system maintains the pH value
within the range indicated by European Directive
98/83/EC concerting the quality of water meant for
human consumption.

DECLARATION OF CONFORMITY:

Filtration systems produced by Laica are compliant with
the following standards:
- Ministerial Decree no. 174 dated 6/04/2004
regarding materials and objects that may be used in
collection, treatment, supply and distribution systems
for water intended for human consumption.
PREPARING THE TAP FILTER
1) Before performing the following steps, wash your hands and thoroughly rinse all the components required to install
the filtering system under running water.
Clean the outer part of the connector and the adapters with a damp sponge and delicate detergent, then rinse
thoroughly with cold drinking water.
Do not use aggressive detergents, solvents, chemical or abrasive products.
2) Remove the aerator from the tap (fig. 1, 2) and choose the best adapter from the ones provided: I, L or M.
1
3) To install the connector using the type I or L adapters, remove the fastening ring from the connector and insert
it on the tap (fig. 3).
4) Screw the adapter onto the tap using the fastening key (H) (fig. 4) to help you, taking extra care when inserting
the seal (N) in the relevant seat (fig. 4).
5) Lower the fastening ring until the adapter is covered (fig. 5) and screw on the connector.
3
2
4
11
- Legislative Decree no. 31, 2nd February 2001,
implementation of Directive 98/83/EC regarding the
quality of water intended for human consumption.
- Regulation 1935/2004/EC regarding materials in
contact with food.
- Regulation (EU) 10/2011 regarding plastic materials
and objects intended to come into contact with food.
- Ministerial Decree no. 25 dated 07/02/2012 (ITALY),
technical provisions concerning equipment designed
for the treatment of water intended for human
consumption.
- Ministerial Decree dated 21st March 1973 and
subsequent amendments concerning packaging,
recipients, tools, intended to come into contact with
food substances or substances for personal use.
Attention: this equipment requires regular
periodic maintenance in order to
guarantee the potability requirements of
the treated drinkable water and
maintenance of the improvements as
declared by the manufacturer.
I L
5
EN
M