Symantec S450 Serie Handbuch Seite 20

M P (MGMT 0:0, 1:0) Two 100/1000/10G BASE-T (RJ-45) copper ports for appliance
ANAGEMENT ORTS
management. The management ports connect to a management network that provides control via con-
figuration software (WebUI), console access, and command line interface (CLI). For enhanced security, the
management ports are isolated from the network traffic on the LAN ports. Each management port includes
two LEDs that exhibit the following behavior.
LED
MGMT Port Active/Link
MGMT Port Speed
(Right)
MGMT Port Status LEDs
S P (R P
ERIAL ORT EAR ANEL
computer) for the appliance's initial configuration. The other serial port is located on the front panel. The
RJ-45 connector for the serial port is wired with the following pin outs.
RJ-45 Pin
1
2
3
4
5
6
7
8
Serial Port (RJ-45) Pin Outs
S R C (S
MALL ISER ARD
sion cards and riser card installation instructions, refer to the S Series WebGuide at:
http://www.symantec.com/docs/DOC9795
L R C (S
ARGE ISER ARD
one full-height PCIe expansion card or one that accepts two half-height PCIe expansion cards. For a list of
supported expansion cards and riser card installation instructions, refer to the S Series WebGuide at:
http://www.symantec.com/docs/DOC9795
Chapter 3 English Instructions
Color
Off
(Left)
Solid green
Flashes green
Off
Flashes green
Flashes amber
) One of two RS-232 serial ports that connects to a terminal (laptop or
Signal
RTS
DTR
TxD
GND
GND
RxD
DSR
CTS
3) Accepts one half-height PCIe expansion card. For a list of supported expan-
LOT
4–5) The S450 is equipped with either of two large riser cards: one that accepts
LOTS
Description
No link
Linked
Activity
100 Mbps
1 Gbps
10 Gbps
DB9 Pin
8
6
2
5
5
3
4
7
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS
20