Maintenance - Foppa Pedretti Foppapedretti Express Montageanweisungen

RESTORING THE CAR SEAT TO ITS ORIGINAL CONFIGURATION
To restore the configuration with shoulder straps, follow the instructions below.
Reposition the crotch strap by inserting the strap with a metal ring into the slot
and checking that the metal stop device is positioned in the lower part of the seat
and correctly locked (26).
At the front of the backrest, between the cover and the shell, hold the metal stop
device of one of the two upper ends of the shoulder straps, then rotate it. At the
same time pull the end of the shoulder strap from the back of the backrest to
remove it from the storage on the backrest (27).
From the front of the car seat, insert the end of the shoulder strap, with a metal
ring, through the slot in the cover and the respective slot on the shell (28), locking
the metal device in its housing on the back of the backrest. Use the correct slot
for your child's height.
Check that the metal stop device at the end of the shoulder strap is correctly
positioned and locked on the back of the backrest (29). Repeat this for the second
end of the harness. The shoulder straps must be inserted into the slots aligned at
the same height. Check that the harnesses are not twisted.
TILTING THE CAR SEAT
See figure (30)
STORING THE INSTRUCTIONS
See figure (31)

MAINTENANCE

• All fabric parts are removable. In the case of light stains, clean with a sponge
moistened with soapy water or hand wash at 30 °C in soapy water.
• Do not use bleach, do not iron, do not machine wash, do not tumble dry.
• The colours may fade if washed at temperatures higher than those indicated.
• The plastic parts may be cleaned with water and soap.
• Do not use harsh detergents (such as solvents).
• ENGLISH •
23