Cleaning & Maintenance - Qlima A 68 Gebrauchsanweisung

Fan Speed Control
Auto Mode
Clean Filter Indicator Light
Dim Mode
UV Control
CLEANING & MAINTENANCE
Keep the A 68 functioning properly by cleaning the cleanable HEPA-type Filter every four weeks of use.
More frequent cleaning will be necessary if the unit is located in an area with a high level of airborne
contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing the A 68 to candle/oil/fireplace soot and smoke is not recommended and will require more
frequent cleaning.
G
Always make sure the A 68 is turned off and unplugged before cleaning.
• Vacuuming will restore performance of the cleanable HEPA-type Filter. However, the filter
may appear stained. This is normal and does not affect performance in any way.
• Do not use water or any household cleaners or detergents to clean the cleanable HEPA-
type Filter.
• The inlet grill may be cleaned (after unit is turned off and unplugged) with a vacuum or a slightly
damp cloth. Cleaning the cleanable HEPA-type Filter
4
52 52
The A 68 has three different speeds of cleaning, LOW, MED and
HI. Press "SPEED" button to cycle the settings and select the fan
speed you desire. The speed state will be shown on the LED dis-
play.
The A 68 is equipped with an air sensor to monitor the quality of
your air. Simply press the Auto button to activate the air monitor-
ing system. The monitor will test the air quality and automatically
adjust the fan speed to remove the air contaminants. The front
of the display is equipped with LED lights to notify you of the air
quality. RED color is for poor, ORANGE for fair and BLUE for good
quality air.
The A 68 Clean Filter Indicator Light will turn on each time the filter
needs to be cleaned. To reset the filter indicator, press the ION and
UV/VOC buttons together for 3 seconds. The CLEAN FILTER light
will flash 3 times and then turn off completely, indicating the unit
has been reset.
If the LED lights are too bright, activate the "Dim Mode" to turn off
the LED lights and the lighted display. To turn on Dim mode, simul-
taneously press Auto and Time buttons. Power indicator, however,
will remain lit.
Press the UV/VOC control button "UV/VOC" to turn on the UV
lamp and the photo catalyst filter.