Jumbo UMOVE S8 Bedienerhandbuch Seite 76

Cautions：
As with any mechanical component, a PLEV is subject to high stresses and wear. The various materials and components may react
differently to wear or fatigue. If the expected service life for a component has been exceeded, it may break suddenly, therefore risking
causing injuries to the user. Cracks, scratches and discoloration in the areas subject to high stresses indicate that the component
has exceeded its service life and should be replaced.
1. Please refer to your local retailer if you want to replace any component. Replacement of any component should be done by the
Retailer of by authorized after-sale offices.
2. A note specifying that the self-tightening nuts as well as the other self-tightening fastenings may lose their efficiency and
that they may need to be retightened. Please periodically check that all screws are correctly tighten.
11 Trouble Shoot
Error Code or Problem
Error Code: E1
Error Code: E2
Scooter would not
power on
Battery not charging
Possible Cause
Motor malfunction
Throttle malfunction
Battery is not charged,
or control panel is damaged
Charger damaged
Troubleshooting Steps
1.Check that the motor wires are firmly connected to the controller
and free of contamination or grit.
2. Restart the scooter
1. Restart the scooter
2. Replace the throttle
1. Make sure the battery is charged.
2. Press and hold the power button for 2 seconds to turn on.
3. Replace the control panel.
Ensure the charger is connected to an electrical outlet that is turned on.
Check if the LED indicator on the charger works.
75