Compex ReadyLINK RE100ATX/WOL Kurzanleitung

Quick Install Guide
Compex
ReadyLINK Express
10/100Mbps Fast
Ethernet Adapters
RE100ATX/WOL
Version 1.4
1. Installing Compex ReadyLINK Express 10/100Mbps
Fast Ethernet Adapter (RE100ATX/WOL)
1. Power OFF the computer and any attached peripherals.
2. Disconnect the cables connected to the computer.
3. Move your keyboard, etc. to clear the work area.
4. Remove the computer's cover casing according to the
manufacturer's instructions.
5. Choose a bus master PCI expansion slot.
6. Unscrew and remove the dummy slot cover.
7. Align and insert the adapter into the slot. Make sure the adapter
fits securely and the connection is good.
8. Fasten the screw on the mounting bracket. Replace the cover
casing.
9. Connect the adapter to the network using UTP cable. Reconnect
other cables to the computer and power on the PC.
10. Please refer to the Software Driver Diskette for Software
Installation.
2. Diagnostic and Installation of Drivers
The INSTALL utility found in the distribution diskette lets you test
the card through the Diagnostic option and driver installation through
the Network Driver option.
3.
The warranty form can be found in the diskette provided.
Disclaimer: Compex, Inc. provides this guide without warranty of any kind, either expressed or implied,
including but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Compex, Inc. may make improvements and/or changes to the product and/or specifications of the product
described in this guide, without prior notice. Compex, Inc will not be liable for any technical inaccuracies or
typographical errors found in this guide. Changes are periodically made to the information contained herein
and will be incorporated into later versions of the guide. The information contained is subject to change
without prior notice.
®
Trademark Information: Compex , ReadyLINK
Inc. Microsoft Windows and the Windows logo are the trademarks of Microsoft Corp. NetWare is the
registered trademark of Novell Inc. All other brand and product names are trademarks or registered
trademarks of their respective owners.
©
Notice: Copyrights 2005 by Compex, Inc. All rights reserved. Reproduction, adaptation, or translation
without prior permission of Compex, Inc. is prohibited, except as allowed under the copyright laws.
Manual Revision by Ong
Manual Number: M-0341-V1.4C Version 1.4, February 2005
FCC NOTICE: This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio or television reception, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the computer into an outlet on a
circuit different from that to which the
receiver is connected.
Caution: Any changes or modifications not expressly approved by the grantee of this device could void the
user's authority to operate the equipment.
FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
ICES 003 Statement
This Class B digital apparatus complies with Canadian ICES-003.
DECLARATION OF CONFORMITY: Compex, Inc. declares that the product:
Product Name: Compex ReadyLINK Express 10/100 Fast Ethernet Adapter
Model No.: RE100ATX/WOL conforms to the following Product Standards:
Radiated Emission Standards: EN55022A, FCC Part 15 Class B
Conducted Emission Standards: EN60555Pt2 conducted emission; EN55022A conducted emission, FCC
Part 15 Class B
Immunity Standards: IEC 801-2; IEC 801-3; IEC 801-4
Therefore, this product is in conformity with the following regional standards: FCC Class B ⎯ following
the provisions of FCC Part 15 directive; CE Mark ⎯ following the provisions of the EC directive.
Manufacturer's Name: Compex, Inc.
Address: 840 Columbia Street, Suite B,
Brea, CA92821, USA
Warranty
® ®
and MicroHub are registered trademarks of Compex,
• Increase the separation between the computer
and receiver.
• Consult the dealer or an experienced radio /
TV technician for help.
European Contact:
ReadyLINK Networktechnology GmbH,
Technical Support
Albert Einstein Straβe 34 / M21,
63322 Rödermark, Germany
[Fax: +49 (60) 749-0668]