SAWAFUJI ELECTRIC Engel SB Serie Handbuch Seite 9

4) Avoid installing the refrigerator close to a kitchen sink or
water faucet. If installed in locations subject to water the
electrical circuits and other parts may be effected.
5) To achieve good cooling performance and less current
consumption, adequate ventilation for the refrigerator is
needed.
a) In the drawing below (Fig.1) : the ventilation air will flow in
the direction of the arrow.
b) Make sure NOT to block the intake vent and outtake vent
of the compressor unit.
c) Recommended vent size : vertical length of 20cm and side
length of 8cm
If blocked, the cooling performance will be affected. And
there is a risk of the failure of the cooling system.
CAUTION
Failing to keep enough ventilation for cooling will result in
reduced product life, poor cooling performance, and excessive
current draw from the battery and will also invalidate the
warranty.
Refer to the picture below to find the correct ventilation.
(See Fig. 1)
Intake vent
8cm(Min.) x 20cm(Min.)
(Fig. 1)
− 8 −
Outtake vent
8cm(Min.) x 20cm(Min.)
EN