Warranty - Lighting Technologies FREGAT LED Serie Betriebsanleitung

Set luminaire on the vertical or bracket-type support
in diameter 48-60 mm by loosening and then
tightening to lock the two screws (18 Nm).
Install luminaire in a horizontal position by loosening
/ tightening the screw of bracket (10 Nm).
ATTENTION!
Check tightening and tighten if needed of the mains cable gland's nut during installation. LUMINAIRE LIFTING
AND CARRYING BY MAINS CABLE IS PROHIBITED, doing this may cause moist protection failure, cable and
luminaire's internal circuits damage.
DIMENSIONS (IN MILLIMETERS)

WARRANTY

- The manufacturer shall repair or replace a luminaire that has been found to be defective under
normal use through no fault of the customer provided that it was delivered, stocked,
mounted/installed and operated in conditions and according to the requirements specified in a
product data sheet, engineering specifications, mounting and service instructions, delivery terms,
rules for technical maintenance of electrical installations and other conditions agreed by the
manufacturer and the customer during the warranty period or expanded warranty period specified
below.
10 Nm
Fig. 7.
Windage area ≈ 0,03 m
18 Nm
2
.