Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Portable solar light
Item no. 56 26 54
Intended use
The product is used as a portable light source and is suited for outdoor use (IP44). Power is supplied via an
exchangeable rechargeable NiMH battery (type AAA). The rechargeable battery is charged via the built-in
solar module.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and
keep them. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Solar light incl. rechargeable NiMH battery (type AAA)
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, strong jolts, flammable gases, vapours and
solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
b) Rechargeable battery
• Correct polarity must be observed while inserting the rechargeable battery.
• The rechargeable battery should be removed from the device if it is not used for a long period
of time to avoid damage through leaking. Leaking or damaged rechargeable batteries might
cause acid burns when in contact with skin. Therefore use suitable protective gloves to handle
corrupted rechargeable batteries.
• Rechargeable batteries must be kept out of reach of children. Do not leave rechargeable
batteries lying around, as there is risk, that children or pets swallow them.
• Rechargeable batteries must not be dismantled, short-circuited or thrown into fire. Never
recharge non-rechargeable batteries. There is a risk of explosion!
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and repairs are to be performed exclusively by an expert or at a
qualified shop.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Operation
Do not install or operate the product under water.
Make sure you choose an installation site from which the product cannot fall, as failure to do so
may cause damage to the product and/or personal injury.
• Place the product at a site with good lighting conditions so the solar module can charge the battery during
daylight hours. Make sure that the solar module is not covered or shaded, i.e. by trees or buildings.
• Flip the product open. Select a suitable installation site (i.e. the edge of a sunshade or marquee). Make
sure that the solar module faces upward. Carefully fold up the product. Due to the built-in magnet, the
product clamps securely to the installation site.
• When using the product for the first time, it will take about 2 days of sunlight to fully charge the battery.
• Subsequently, the rechargeable battery will take approx. 12 hours to be fully charged. A fully charged
rechargeable battery will operate the solar light for about 8 hours.
• Turn the solar light on/off by pushing the on/off switch located on the side of the product. When turned off,
the switch sticks out from the housing slightly farther.
The rechargeable battery is charged whenever sunlight falls on the solar module, regardless
of the switch position. This means that the rechargeable battery will be charged even when the
product is turned off.
The solar light turns on automatically when the lighting level drops below 20 lux.
Version 11/13
The solar light turns off automatically when the lighting level exceeds 200 lux.
• The LEDs can be swiveled. Apply light pressure to the outer area of the transparent LED cover to adjust
the beam of light's direction.
• Turn off the product using the on/off switch and remove the battery (see following segment) for extended
periods of disuse.
Replacing the rechargeable battery
• Replace the rechargeable battery when the luminous period diminishes noticeably although the
rechargeable battery is fully charged.
• Make sure the product is turned off and then flip the product open.
• The rechargeable battery is located in the same side of the housing as the LED unit. Use a Phillips
screwdriver to loosen the six screws. Turn the product over. Carefully remove the LED unit. Take care not
to sever any internal cable connections.
• Remove the rechargeable battery. Insert a new, identical rechargeable battery (see "Technical data") into
the rechargeable battery recess. Heed correct polarity ("+" = positive, "–" = negative).
• Reassemble the product.
Maintenance and cleaning
• The product does not require any maintenance except for potential rechargeable battery replacement or
occasional cleaning. Turn off the product and allow the LEDs to cool down sufficiently.
• To clean, use a clean, dry, lint-free cloth. For stubborn dirt, slightly dampen the cloth with water. Allow the
product to dry completely before continued use.
• Never use any aggressive cleaning agents or chemical solutions as they may cause damage to the
housing or the product to malfunction.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Remove the inserted rechargeable battery and dispose of it separately from the product.
b) Rechargeable batteries
You as the end user are required by law (Battery Ordinance) to return all used rechargeable batteries.
Disposing of them in the household waste is prohibited.
Contaminated rechargeable batteries are labelled with this symbol to indicate that disposal in the
domestic waste is forbidden. The designations for the heavy metals involved are: Cd = Cadmium,
Hg = Mercury, Pb = Lead (name on rechargeable batteries, e.g. below the trash icon on the left).
Used rechargeable batteries can be returned to collection points in your municipality, our stores
or wherever rechargeable batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
a) General
Rechargeable battery ....................... NiMH, 1.2 V, 500 mAh, type AAA
Illuminant .......................................... 5 x LED
Colour temperature ........................... 7000 – 9000 K
Protection type .................................. IP44
Beam angle ...................................... 110º
Operating / storage conditions .......... -20 to +45 ºC, 20 – 100 % RH
Dimensions (Ø x H) .......................... 108 x 40 mm
Weight .............................................. approx. 180 g
b) Solar module
Operating voltage ............................. 2.2 V (±0.2 V)
Current .............................................. 38 mA (±3 mA)
Dimensions (W x H) .......................... 58 x 54 mm
These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
V1_1113_02-ETS-Mkde
Werbung
