Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The coupling of up to four remote controls - which complies with the alarm strips 1 to 4 - and up to 8 sensors -
which complies with the alarm strips 5 to 12 – with the main unit is the last step.
4.1. REMOTE (Coupling Remote Control with Main Unit)
As preparation unscrew the remote control and keep one of its buttons (S1 –S4) pressed while inserting the
battery. Now the LED should flashes. Reassemble the remote control and close it.
Enter the number of the desired memory space from 1 to 4 into the main unit and confirm the input with #.
Now press any key of the remote control which should be correlated. If the main unit gives an acoustic signal
the allocation was successful.
Repeat this procedure for every single remote control.
4.2. ARM ZONE (Coupling Magnetic Contact with the Main Unit)
Enter the number of the desired memory space from 5 to 12 into the main unit and confirm the input with #.
Now open a magnetic contact. If the main unit gives an acoustic signal the allocation was successful.
Repeat this procedure for every single magnetic contact.
4.3. DEL (Cancellation of all Couplings)
By choosing this item all saved allocations between remote controls or magnetic contacts and the main unit will
be cancelled.
Functional Test of the Alarm-System (The Walk-Test):
•
After the installation of the alarm system use the AWAY ARM-button of the remote control.
•
Now the alarm system is armed and activated inclusive the motion detector.
•
Move in the monitored range of the motion detector.
•
The motion detector will recognize your presence and transmits a signal to the main unit.
•
After the expiration of the entry delay the integrated siren of the main unit as well as the piezo-siren
raise the alarm.
•
Break-up the alarm instantly by entering the user password at the main unit.
•
Press now the HOME ARM-button of the remote control. Now only the alarm stripes connected to the
magnetic contacts are activated.
•
If you open a saved door or window now the sirens should give alarm.
As a basic principle do not switch the alarm-system from the HOME ARM-mode to the AWAY ARM-mode (or vice
versa) directly. This can cause operational problems. Just use the DISARM-button of the remote control always
before you activate another mode.
1.remote
3. del
P2008 © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
2.arm zone
530-333
Werbung
