Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Startup - Joy-it JOY-PI Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für JOY-PI:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2.

INITIAL STARTUP

Before you can put the Joy-Pi into operation, insert the supplied Micro-SD card into the
slot provided on the back of your Raspberry Pi.
Then plug the Aux adapter into the Aux port of the Raspberry Pi.
Plug the HDMI cable, which is located on the left side of the case, into the Raspberry Pi's
HDMI port.
Now place the Raspberry Pi in the Joy-Pi as shown in the picture below and tighten the
four screws.
Now plug the USB cable into one of the USB ports and connect the GPIO bar of the
Raspberry Pi to the one on the Joy-Pi, using the supplied cable.
To power the Joy-Pi, plug the supplied power cord into the port on the right side of the
case.
Your Joy-Pi is now ready for use.
Published: 29.10.2018
Copyright by Joy-IT

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis