Getting Started - Clearaudio Balance+ Bedienungsanleitung

Getting started:

1. Switch off all your hi-fi system components and connect your Balance+ phono-preamplifier.
2. Follow the set-up adjustment steps described before.
3. Connect the Balance+ with 15-pole Sub-D connector to the power supply unit.
4. Connect the power supply to the mains supply and switch the unit on.
5. Now you may switch on your amplifiers.
Please note:
To prevent overheating of electronic parts never cover or put anything on top of the Balance+
preamplifier or the power supply.
Clearaudio recycles your used equipment free of charge.
Don't dispose the unit through the domestic waste.
Main plug phase polarity:
Ex factory the mains plug 'live' pin is marked with a red spot.
If applicable in your area (US and EU connectors will permit this, UK 3-pin plugs will not) and where
no mains phase testing equipment is available, try to find the correct mains phase by alternately
turning the plug and listening. You will hear the difference!
Please note:
Phonostages are devices designed to provide a very high level of amplification. This is necessary
because the electrical signal generated by a phono cartridge is extremely low (usually less than one-
thousandth of a volt). The job of the phonostage is therefore to accurately equalise the phono signal
and boost it to line level (measured in volts).
However, phonostages are by nature extremely sensitive, which leads to the potential problem that
high-frequency interference may also be amplified to a point at which it becomes noticeable.
Unfortunately it is not possible to completely protect the sensitive phonostage circuitry from this
interference without degrading its high fidelity performance. Therefore care must be taken to position
the phonostage away from sources of high frequency interference such as mobile phones, modems
and powerline communication systems (PLC) in which data is sent over the mains power network.
Please note:
If the Balance+ is not in use for an extended period,
switch it off at the rear panel
Page / Seite 4
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen; Germany
Tel/Phone: +49 9131 40300100; Fax: +49 9131 40300119
www.clearaudio.de
www.analogshop.de
info@clearaudio.de
Balance+
User manual / Bedienungsanleitung
 clearaudio electronic GmbH 2014