Post Operation / Storage - NORSE SK155 Kurzanleitung

SK155
The surest way to avoid damaging surfaces:
1. Adjust the spray lance / nozzle to a wide spray pattern.
2. Place the nozzle approximately 4-5 feet from and 45 degrees to the cleaning surface.
3. Vary the spray pattern, spray angle and the distance to the cleaning surface until optimum cleaning
efficiency is achieved without damaging the surface.
Looking After your Product
1. This pressure washer is not meant to pump hot water. Never connect to a hot water supply.
2. Never operate the unit for more than one minute without spraying water. This will cause a heat build-
up that can damage the pump.
3. Only use the nozzles supplied with the machine.
4. Never store the pressure washer outdoors or where it could freeze. The pump will be seriously
damaged. Any components with water left inside will also be damaged, e.g. the pressure gun.
5. Release the trigger when changing the spray pattern. Failure to do so could result in damage.
6. Do not operate the pressure washer with the inlet water screen removed. Be sure to keep the screen
clear of debris and sediment.
7. Make sure you clean the machine every three months and inspect the filter and the nozzle prior to
every use, ensuring there is no debris that may impair use.

Post operation / storage

• Do not store the pressure washer outdoors or in a location where it may freeze. Any water left in the
machine, spray gun or any other components will expand if allowed to freeze, causing damage.
• Always turn the motor off before turning the water supply off.
• Never disconnect the hose from machine while the system is pressurised. To de-pressurize, turn the
motor off, then turn the water supply off and squeeze gun trigger 2-3 times.
1. Release the trigger (10d).
2. Turn the on/off switch (6) to "O" (off).
3. Turn off the water tap.
4. Press the trigger (10d) to release the pressure still present in the product.
5. Lock the trigger (10d) by pressing the activate button (10a).
6. Separate the water hose from the water supply.
7. Disconnect from the power supply.
8. Dismantle the accessories in the reverse sequence of the assembly instructions if you are not going to
use this product for a long period of time.
9. Check, clean and store the product.
English
© NØRSE 11