Herunterladen Inhalt Inhalt Diese Seite drucken

General Cleaning - NORSE SK155 Kurzanleitung

Electric pressure washer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
SK155
Detergent application
Only use detergents formulated for pressure washers. Test the detergent in an inconspicuous area before
use. Follow the manufacturer's label directions for mixing the correct concentrations of detergent to
water.
1. Unscrew the top of detergent applicator and fill with detergent.
2. Put the top of detergent applicator back on.
3. Set nozzle to detergent feature
4. Apply the detergent so it thoroughly covers the cleaning surface. Apply from bottom to top to prevent
the detergent from sliding down and streaking.
5. Allow the detergent to remain on the surface for a few minutes. This is a good time to use a brush to
lightly scrub heavily soiled areas. Never allow detergent to dry on the cleaning surface.
6. Remove detergent applicator from gun and replace with the lance.
7. Rinse detergent from surface.
8. Rinse the detergent applicator with clean water following each use.
9. Final rinse. Make sure you thoroughly rinse the surface and that all detergent has been removed.
Shut down
1. Make sure all detergent is flushed from the system.
2. Turn off the motor.
3. Turn off the water supply.
4. Trigger the gun to de-pressurise the system.
5. After each use, wipe all surfaces of the pressure washer with a clean, damp cloth.

General cleaning

Distance from Cleaning Surface
Another factor that determines the impact force of the water is the distance from the lance end / spray
nozzle to the cleaning surface
Angle to the Cleaning Surface
When spraying water against a surface, maximum impact is generated when the water strikes the
surface head on. However, this type of impact tends to cause dirt particles to embed in the surface,
thereby preventing the desired cleaning action.
The optimum angle for spraying water against a surface is 45 degrees.
Avoid Damaging Surfaces
Damage to surfaces occurs because the impact force of the water exceeds the durability of the surface.
Never use a narrow high impact stream or a turbo / rotary nozzle on a surface that is susceptible to
damage.
10
English
© NØRSE

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis